Drawing-based components
Solid PTFE strips cut to width and length for guides, wear interfaces and insulation. Specify straightness, thickness and mounting details for the contact path.
Procurement specification
These components are made to the required geometry. The drawing defines the finished dimensions and interfaces.
| Material form | Solid PTFE sheet or film strip |
|---|---|
| Cut dimensions | Width, length and thickness |
| Mounting | Mechanical retention or specified bonding treatment |
| Functional surface | Sliding face, insulating face or release contact |
| Optional details | Holes, chamfers and drawing-based end profiles |
A strip gives a continuous contact path. State the supported span and the surface it covers so the width and thickness follow the available mounting area.
For guides, specify fastener positions and the end shape. A straight unmounted strip is a different supply item from a drilled guide secured along its length.
A solid PTFE strip has no woven carrier. Fabric-backed release tape and film adhesive tape are separate products with different handling and mounting behavior.
Untreated PTFE is difficult to bond. If adhesive mounting is required, define the treatment, adhesive and substrate together rather than assuming the bare strip is self-adhesive.
Specific answers
No. Adhesive or etched bonding options must be included in the order specification.
Yes. Show the hole positions, diameters and any countersinks with the required strip length.
Quote the component
Provide width, length, thickness, quantity and mounting details. Include sliding load or electrical requirements and any bonding treatment.
Send Drawing & DimensionsContinue with the right requirement